热缩片钥匙扣挂饰
原文链接：https://tabithaannthelostsock.blogspot.com/2024/11/shrinky-dink-art.html
日期： 2024-11-21
标签： 钥匙扣、挂饰、塑料、热缩、Shrinky Dink
热缩片制作小贴士：裁剪与上色
- 在磨砂面（雾面）上色。
- 尽量将图案画至纸张边缘。
- 烘烤前打孔（用于钥匙扣或项链挂环），注意孔洞也会随热缩而缩小。
- 使用记号笔类永久性马克笔和/或彩铅上色。
- 注意：塑料热缩后，颜色会变深。
- 初始形状在受热时可能出现翘曲。
我的热缩片尺寸为6英寸×8英寸，一张可排布3个设计。
设计1：怪女孩俱乐部（Weird Girl Club）
设计2：飞蛾（Moth）
设计3：艺术猎豹（Art Cheetah）
我于250华氏度烘烤2–3分钟（较大尺寸需更久）。
确保光面（未着色面）朝下放置。
密切观察：热缩片会先卷曲，再展平；一旦完全展平，立即取出。
取出后，我用一本书压在其上约30秒，确保彻底压平。
烘烤前后对比
尺寸参照
整体收缩率约为60%
可直观看出加热前后的尺寸差异。
成品尺寸缩减超过一半。
圆形及对称造型易发生翘曲。
建议选择对轻微翘曲不敏感的设计。
若需确保颜色不脱落，可在烘烤冷却后喷涂丙烯酸封层剂。
❌ 注意：该封层剂不可用于酒精马克笔，否则会导致颜料晕染渗出。
热缩片钥匙扣挂饰
Original: https://tabithaannthelostsock.blogspot.com/2024/11/shrinky-dink-art.html
Date: 2024-11-21
Tags: keychain, ornament, plastic, shrink, shrinki dink
Shrinky Dinks TIPS FOR Cutting and Coloring
-Color on frosted side.
-Draw design as close to edge as possible.
-Punch any holes (for keychains or necklace loops) before you bake them
and remember that holes shrink too.
-Color with
sharpie type permanent markers
and/or colored pencil.
-Keep in mind that colors darken as the plastic shrinks.
- Initial shape may warp with the heat.
My sheets were 6 by 8 inches. I fit 3 designs on it.
Design 1, Weird Girl Club
Design 2, Moth
Design 3, Art Cheetah
I heated them for 2-3 minutes (longer on bigger ones) at 250.
Make sure glossy/non colored side is down.
Watch them close. They will curl up then flatten out. When they get flat, take them out.
After removal, I laid a book on top for about 30 seconds to assure flatten out.
Before and After
Size Reference
It shrinks about 60%
You can see the difference in size before and after the heat.
It shrunk over half size.
The round and symmetrical ones warped.
I recommend doing a design that is okay if it warps a little.
.
If you want assurance that the color will not come off, spray with an acrylic sealant
AFTER the oven heat.
❌ Ilearned you cannot use this on alcohol markers or it bleeds out.
